Anchorage Type	Tendon Type 59... (0.5" system)
59 ...	01	02	03	04	05	06	07	08	09	12	15	20	27	37
Multiplane Anchorage MA
Plate Anchorage SD
Bond Head Anchorage ZF/ZR
Loop Anchorage HV

Other size tendons on request
Plate Anchor SD and Flat Anchor FA use 0.5" Jumbo Wedge

Anchorage Type	Tendon Type 68... (0.6" system)
68 ...	01	02	03	04	05	06	07	08	09	12	15	19	27	37
Multiplane Anchorage MA
Plate Anchorage SD
Mono Anchorage EV
Bond Head Anchorage ZF/ZR
Loop Anchorage HV
Flat Anchorage FA

 Other size tendons on request

Multiplane Anchorage MA

The two-part multiplane anchorage is primarily used for longitudinal tendons in beams and bridges. The wedge plate and the conical anchor body with usually three load transfer planes introduces the prestressing force continuously into the member with minimal front area. The separation of anchor body and wedge plate makes it possible to insert the strand after casting the concrete. The wedge plate self-centers on the anchor body, providing consistent assembly and installation as well as trouble-free stressing. pocket former for each anchorage system on request

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kips/kN] from to yes 287/1,302 2,168/9,644 Multiplane Anchorage MA - Technical Details

Plate Anchorage SD

The single unit plate anchorage is designed for plate structures as well as transverse tendons in bridges. Small edge and center distances allow for an economical anchorage layout in condensed situations. pocket former for each anchorage system on request

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kips/kN] N/A  1,040/8,234 Plate Anchorage SD - Technical Details

Bond Head Anchorage ZF/ZR

Primarily used with prefabricated tendons, it is also possible to fabricate this anchorage on site. The strand wires are plastically deformed to ensure a safe load transfer up to ultimate capacity in the area of the bond head proven in static as well as in dynamic applications. Depending on the boundary conditions, either a rather flat or a bulky bond head anchorage pattern is available.

stressing anchorage dead end anchorage accessible not accessible no no yes coupling ultimate load 0.5 [kips/kN] from to no 41.3/184 1,115/4,961 coupling ultimate load 0.6 [kips/kN] from to no 58.6/261 1,582/7,037 Bond Head Anchorage ZF/ZR - Technical Details

Loop Anchorage HV

Often used in large plate-shaped structures, walls in off-shore structures or LNG tanks with generally static loadings. The 180° loop should be positioned in the center of the tendon to allow for non-slippage during simultaneous two-end stressing.

stressing anchorage dead end anchorage accessible not accessible no no yes coupling ultimate load [kips/kN] from to no 82/372 1,169/5,301

Flat Anchorage FA

The Flat Anchorage of max. 4-0.62" strands in one plane to deviate into one oval duct is designed to be installed in thin members such as transverse Post-Tensioning of the top slab of box-girder bridges and prestressed flat slabs.

stressing anchorage dead end anchorage accessible not accessible yes yes yes coupling ultimate load [kips/kN] from to no 175/782 234/1,043 Flat Anchorage FA - Technical Details