Anchorage Types

Anchorage Types

Multistrand Post-Tensioning System

Anchorage Types

Available Anchorage Types

Anchorage TypeTendon Type 59... (0.5" system)
59 ...0102030405060708091215202737
Multiplane Anchorage MA
Plate Anchorage SD
Bond Head Anchorage ZF/ZR
Loop Anchorage HVx



Multistrand Post-Tensioning Anchorages
Anchorage TypeTendon Type 68... (0.6" system)
68 ...0102030405060708091215192737
Multiplane Anchorage MAxxxxxxxx
Plate Anchorage SDx
 Mono Anchorage EV x
Bond Head Anchorage ZF/ZRxxxxxxxxxxx
 Loop Anchorage HV xxxxxxxxxxxx
Flat Anchorage FAxx

Multiplane Anchorage MA

Multiplane Anchorage MA

The two-part multiplane anchorage is primarily used for longitudinal tendons in beams and bridges. The wedge plate and the conical anchor body with usually three load transfer planes introduces the prestressing force continuously into the member with minimal front area. The separation of anchor body and wedge plate makes it possible to insert the strand after casting the concrete. The wedge plate self-centers on the anchor body, providing consistent assembly and installation as well as trouble-free stressing.

pocket former for each anchorage system on request

Plate Anchorage SD

Plate Anchorage SD

The single unit plate anchorage is designed for plate structures as well as transverse tendons in bridges. Small edge and center distances allow for an economical anchorage layout in condensed situations.

pocket former for each anchorage system on request

Bond Head Anchorage ZF/ZR

Bond Head Anchorage ZF/ZR
Bond Head Anchorage ZF/ZR

Bond Head Anchorage ZF/ZR

Primarily used with prefabricated tendons, it is also possible to fabricate this anchorage on site. The strand wires are plastically deformed to ensure a safe load transfer up to ultimate capacity in the area of the bond head proven in static as well as in dynamic applications. Depending on the boundary conditions, either a rather flat or a bulky bond head anchorage pattern is available.

Loop Anchorage HV

Loop Anchorage HV

Often used in large plate-shaped structures, walls in off-shore structures or LNG tanks with generally static loadings. The 180° loop should be positioned in the center of the tendon to allow for non-slippage during simultaneous two-end stressing.

Flat Anchorage FA

Flat Anchorage FA

Flat Anchorage FA

The Flat Anchorage of max. 4-0.62" strands in one plane to deviate into one oval duct is designed to be installed in thin members such as transverse Post-Tensioning of the top slab of box-girder bridges and prestressed flat slabs.

DSI Image Trailer

DYWIDAG-Systems International USA Inc.

use our contact form
send us an e-mail
or call us:
+1-630-739 1100